High Pass Sharpening

In Adobe Photoshop, there are many different ways to do similar things and each way has its own strengths and weaknesses.  This can also be one of the features of Photoshop that tends to be the most initimidating.  As far as sharpening goes, there are countless different ways to help to sharpen your photos, and this article will show you a method that you may or may not have tried.

Let’s try to demystify things somewhat and show you an easy and repeatable way to sharpen your images using the High Pass Filter.

It is important to note that this is a post-processing technique and does not have any effect on the “focus” of the photo, nor will it fix a blurry photo.  Sharpening a photo in post-processing simply enhances the contrast between light and dark areas, giving it the appearance of looking “sharper” or “crisper”.  I am going to tell you how to perform this technique in a simple, Kelby-esque way, leaving all of the techy explanations behind and just concentrating on how to make the picture look better, since that’s all that matters anyway.

 

SHARPENING YOUR IMAGES USING THE HIGH PASS FILTER

After your open your image into Photoshop, and finish making all of your other adjustments, it will be time to sharpen your image.  I HIGHLY recommend always sharpening on a duplicate layer and not on the background layer, as this will allow you to make additional adjustments rather than being committed to whatever you had just done.

 

1.  Duplicate your background layer….  (keyboard shortcut Ctrl+J)

2.  Make sure LAYER 1 is selected in the layers palette.

3.  At the top of the screen, click FILTER >> OTHER >> HIGH PASS.  (Choose DON’T FLATTEN if prompted.)

4.  Set the radius anywhere between 2-10 pixels.  When you start to see fine details show up iin the gray panel, you have dialed it in strong enough.  Click OK.

5.  Now go to the top of the screen and click IMAGE >> ADJUSTMENTS >> Hue/Saturation.

6.  Dial the saturation all the way down to -100.  This will prevent or remove any color errors from using the high pass filter.

7.  In the layers palette, change the blending mode to OVERLAY and voila!..   There is your full-color, sharpened image.

8.  You should now have two layers, BACKGROUND and LAYER 1.  LAYER 1 is the sharpened layer and the BACKGROUND layer has been unaffected.  If the image appears too sharp, just lower the opacity of LAYER 1 until it looks suitable.  Because you have two layers, you can even now create a layer mask and paint in and out of the mask to control where you want the sharpening to lie.  Once you are finally happy, flatten the layers (LAYER >> FLATTER, or Alt+L+F).

9.  DONE!

[ad code=1 align=center]

You might also like:

This entry was posted in Post-Processing and tagged , , , , , , .

Post a Comment

Your email is never published nor shared. Required fields are marked *

*
*